Borohydride Reduction of Vanillin to Vanillyl Alcohol
Essay Preview: Borohydride Reduction of Vanillin to Vanillyl Alcohol
Report this essay
Borohydride Reduction of Vanillin to Vanillyl Alcohol
Operational Organic Chemistry a Problem Solving Approach to the Laboratory Course, 4th edition, by John Lehman, Experiment 29, pgs. 246 – 254.
Introduction
The purpose of this experiment is to see if vanillin can be synthesized to vanillyl alcohol through reduction with sodium borohydide.
Balanced Equations
Calculations of Quantities of Reactants Required
List of Material and Supplies Needed
Chemicals:
Vanillin
Sodium Borohydride
Vanillyl Alcohol
152.2
37.83
154.2
amount
density
Experimental Procedure
Use a 125 mL Erlenmeyer flask to dissolve 25.0 mmol of Vanillin (FW 152.15 g/mol) in 30 mL 1M NaBH4.
If the mixture does not dissolve after 5 minutes of continuous stirring add another 5 mL NaBH4 and cool the solution to just below 15°C.
In a small beaker dissolve 12.0 mmol of NaBH4 (FW 37.83 g/mol) in about 6 mL of 1 M NaBH4.
Remove the vanillin solution from the ice bath, and add the NaBH4 solution in small portions to the vanillin over a 5 minute period. Make sure the temperature of the vanillin solution does not rise above 25 °C. Once all the NaBH4 has been added, let the solution sit at room temperature for 30 minutes with frequent swirling.
Place the reaction mixture in an ice bath and carefully acidify the solution with 6 M hydrochloric acid. Perform this step carefully, as the solution will foam and foam will contain vanillyl alcohol.
Check the pH with litmus paper to ensure it is acidic. Cool the mixture in the ice bath for an additional 10 minutes.
Collect the vanillyl alcohol by vacuum filtration and wash the crystals with cold water. Store the product in a container for a week and once the sample has dried determine its mass and melting point.
Data and Results
Mass of product with filter paper and weigh boat = 2.420g
Mass of filter paper and weigh boat alone = 2.200g
Mass of vanillyl alcohol obtained = 0.220g
Melting point = start temperature of 97°C and complete melting at 99°C
Discussion and Conclusion
The experiment attempted to reduce vanillin to vanillyl alcohol using a reduction reaction with sodium borohydride. The reduction reaction was completed in a base medium with NaOH because an acidic medium such as H3O+